Wagner SprayTech Power Painter Manuel du propriétaire télécharger pdf (Page 11)

English

Spraying

Technique

Start

2. Remove the atomizer valve and

see if it needs to be cleaned or

replaced (see page 18).

Also check the pump housing

opening for any dirt or other

obstruction and clean if

necessary.

1. Unplug the sprayer

immediately.

Remove the adjustable spray tip

assembly.

Note: Remove the adjustable spray

tip assembly by turning the spray

tip nut (a), not the spray adjustment

guard (b).

3. Put the atomizer valve back

in place, making sure it can

seat properly without any

obstruction.

Thread on the adjustable spray

tip assembly by turning the

tip nut clockwise and tighten

rmly by hand.

Start

1. Keep your arm moving at constant speed and keep the

sprayer at a constant distance from the surface. The

sprayer should be triggered at the beginning of the stroke

and released at the end of the stroke.

2. Keep the sprayer at a consistent distance to the

surface. This means moving your entire arm back

and forth rather than just exing your wrist. Overlap

each stroke by 50%.

The adjustable spray tip assembly produces

a pattern that can be adjusted horizontally or

vertically. Rotate the spray adjustment guard

(b) as shown.

Spraying horizontally (side to side):

Spraying vertically (up and down):

To prevent an injection hazard,

make sure the sprayer is unplugged

before you adjust the spray tip.

Make sure the spray tip nut (a) is

sufcientlyhandtightenedpriorto

spraying.

Adjusting the spray

tip assembly:

If a large amount of material is leaking from behind the adjustable spray tip assenbly, turn

off the sprayer immediately or the sprayer could be damaged. The sprayer will leak from

behind the adjustable spray tip assembly if the tip nut is not tightened firmly. If you notice

material leaking from this area, follow the steps below.

IMPORTANT:

Keep stroke

even

End

stroke

Start

stroke

Pull

trigger

Release

trigger

Move steadily

* Slower speeds (if equipped) will allow to you get closer to the spray surface.

Aproximately

10 to 14 inches*

1 2 3

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 21 22

Commentaires sur ces manuels

Pas de commentaire

Wagner SprayTech Power Painter Manuel du propriétaire Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de pulvérisation fine de puissance Wagner SprayTech Power Painter