Wagner SprayTech Power Painter Manuel du propriétaire télécharger pdf (Page 18)

English

Replacement

parts

Start

Notice:

Parts of your sprayer wear out with use and

require regular replacement. They include

the atomizer valve, piston and spring. These

parts are not covered by your sprayer

warranty.

Moreabrasivematerialssuchaslatexpaints

and stains cause these parts to wear out

faster than less abrasive materials such as

oil-based paints and stains, thin stains and

sealers.

Atomizer valve:

The atomizer valve is shaped to cause the material to spin as it comes out

of the sprayer. The spinning breaks the material up into a ne spray. As

more material goes through the atomizer valve, it wears out the valve and

the shape of the valve changes. When it changes too much to produce a

good spray pattern, the valve needs to be replaced.

2 3

Front view of a good atomizer valve.

Front view of a atomizer valve after spraying 7-10 gallons

of latex paint. Replace.

Front view of a atomizer valve after spraying 7-10 gallons

of latex stain. Replace.

Piston and Spring:

The average life of a piston and spring will vary depending on the types of

material being sprayed.

Replace the piston if the sprayer takes longer than 20 seconds with the

suction tube to prime when well lubricated, or if there is an excess amount

of material leaking, refer to the troubleshooting suggestions listed in this

manual. Replace the spring if you notice that it is broken when you clean

the sprayer.

To replace either the atomizer valve or the piston and spring, follow

the Cleanup instructions on page 12-13, and replace the old parts with

new ones. When replaced, follow Reassembly instructions, (page 15).

1 2 ... 13 14 15 16 17 18 19 20 21 22

Pas de commentaire

Wagner SprayTech Power Painter Manuel du propriétaire Page 18